axiotrax device - print files (standard case, revision R25)
===========================================================

Ready-to-print plates (Bambu Studio / Bambu P1S, 256 x 256 bed)
---------------------------------------------------------------
plates/axiotrax-plate.3mf                 ASA, single colour: case, cradle, back cover and sun cover
                                          on one plate (logos and branding sunk into the surface)
plates/axiotrax-plate-2color.3mf          ASA, two colours (AMS): same plate, with the logo and the
                                          sun-cover branding as flush 0.6 mm inserts on filament 2
plates/axiotrax-tpu-plate.3mf             TPU: one set (button pad, USB plug, display gasket,
                                          window gasket, 4 post caps)
plates/axiotrax-tpu-plate-4up.3mf         TPU: four sets (pads, plugs, display gaskets, post caps)
plates/axiotrax-tpu-window-gaskets-4up.3mf  TPU: four window gaskets

Individual STL files (for other slicers)
----------------------------------------
stl/asa/  axiotrax-case.stl             case, single colour (sunk logo)
          axiotrax-case-2color.stl      case, two colour  + axiotrax-logo-inlay.stl (filament 2)
          axiotrax-cradle.stl           cradle (mast-mount slider)
          axiotrax-back.stl             back cover
          axiotrax-sun-cover.stl        sun cover, single colour
          axiotrax-sun-cover-2color.stl sun cover, two colour + axiotrax-sun-cover-inlay.stl (filament 2)
stl/tpu/  axiotrax-buttons.stl          button pad
          axiotrax-plug.stl             USB port plug
          axiotrax-gasket.stl           display gasket
          axiotrax-window-gasket.stl    protective-window gasket
          axiotrax-post-cap.stl         back-cover post cap (print 4)

For a two-colour print from STLs, load the part and its inlay together as one object with
two parts and assign the inlay to the second filament.

Print settings
--------------
ASA:  0.20 mm layers, 2 walls, 15 % grid infill, no supports, XY hole compensation 0,
      enclosed printer (chamber heat helps). Do not scale parts in the slicer.
TPU:  100 % infill, 3 walls, flow about 1.03-1.05, print slow. Pad: plungers up.
      Plug: cap face down. Gaskets: flat side down, bead up.

Protective window (not printed)
-------------------------------
The case takes a 1.0 mm clear polycarbonate sheet plus 0.16 mm polarizer film (protective
films removed), cut to a 93.2 x 69.7 mm rectangle, held by the TPU window gasket.
